Magnetic Tile for Chess Board

7/10/25 - Added f3d file. Its a bit cursed because I created it from the mesh of the original square. This is a remix of the tile piece from vmLOGIC's chess set. I don't have a spare plate, but I have a ton of magnets. So this is a little taller than the original piece (2.4mm vs 4mm) to accommodate what I had on hand. Designed for a 10x3mm magnet. Fit is kinda tight, but I never had an issue fitting them in. A dab of glue will help the magnet stay down while printing, but it is attracted to the plate itself. Pause at layer #20 to insert magnet.