Magnetically Attached Keychain for 6 Card Wallie

This model is a simple replacement for the original 6-Card Bumper It uses 6x2mm magnets To Print the Key Fob, split the model in half in the slicer along the keychain ring. the Orientation of the inserted Magnets is important, since the repelling-forces of the magnets strengthen the force with which the key-fob is held to the magnetic bumper. the small locking-lip on the bumper will prevent the key-fob from being pulled out horizontally. When Printing, pause the print just before the holes for the magnets get covered up, insert the magnets in the correct orientation and resume the print. The Build Plate must not exceed 80°C, or else the magnets might get demagnetized / weakened due to high temperature.