Mains Relay or WiFi Switch Module Enclosure

I designed this Enclosure as I needed an Enclosure relatively strong in fabrication to house a elay which would operate my pump on a Water Cooled Spindle motor. Can also be used to enclose a WiFi Switch. It was designed to take 3mm Brass Heated inserts and printed with PET-G filament. There is a 10mm hole cast in the side to take a PG7 cable gland' which can be blanked with a 10mm grommet if not needed. PLEASE NOTE THIS IS NOT INTENDED FOR OUTSIDE USE - IT IS NOT WATERPROOF All the Hardware, Sockets etc. can be found on Amazon https://amzn.eu/d/043kbv4c AC 3 Pin Mains Socket https://amzn.eu/d/0fh7qmnE AC Switched/Fused input https://amzn.eu/d/04YGkZPs relay Module