Manhole cover for the Transformers MPM-15 Brawl and it's knockoff as well as it's oversized knockoff

This is the cover for the big hole left in the Masterpiece Movie figure MPM-15 Brawl by design. I designed it primarily for the oversized knock off (OSKO) that I have, but I also sized it down to fit on the official and the 1:1 knockoff as well. I had to make it slightly raised with lip so that it would not fall into the figure. I wanted it to be removable, but semi-permanent and able to stay in place for transformation. It's not so tight that you can't easily knock it out, but should stay in place if you press it firmly. I have tested it, and it will pop out DURING transformation, but you can easily pop it back in place. I couldn't make it any thicker though as it would hit his head. It will need to be painted, I haven't had the chance to match paint to either one and I am not sure how well a FDM version of this will take paint to match with the figure compared to a resin. Time will tell. As far as with my FDM, I just left everything on defaults, .4mm nozzle at .2mm with no supports using PLA, no issues. I use a Bambu P1S