Mechanical Quick Grab/Release Phone Stand

This is a remix of the original Mechanical Quick Grab/Release Phone Stand with several modifications for improved usability and fit. Printing Details: Material: PLA Layer Height: 0.16mm Wall Loops: 2 Infill: 15% Infill Pattern: Gyroid Supports: Not required Assembly & Spring Recommendation: This model consists of 16 model files . You'll need to print 1 of all the parts except the short bolt, slider, stand bolt, and stand nut where you'll need to print 2 of each. The assembly process is straightforward, and the only non-printed component needed is an extension spring . The original design recommended a 5mm x 10mm extension spring, but I used a 5.5mm x 25.5mm spring instead, which works but isn't a perfect fit. Potential Improvement: One area that could be reinforced is the adjustable hinges , where the bolts and nuts secure them in place. Strengthening this section would help prevent them from loosening over time.