Mevo Start sun shade + lens cover

I chose to design a minimalistic cover (it slides on snug) that allows a breeze to penetrate so heat doesn't get trapped. It offers a little protection if dropped, depending on the angle. Definitely not rainproof of course. Lens cover also is compression fit If either is too tight after printing, just warm them up a little with a lighter/torch/etc, slide over the camera, and let cool. I didn't need to do that with mine since I made design adjustments and re-prints to fit snugly. Recommendation: slide a little microphone foam in between the cover and the camera's three microphone holes on the top, to cut out almost all wind noise. Fusion .f3d file is included if you want to modify the model