Milwaukee M12 battery holder for Wall Control Pegboard

A simple pegboard storage for Milwaukee M12 power tool batteries, adapted to work with the DDD Wall Control pegboard system . There are versions for 1, 2 or 3 batteries (I have only printed the 3x). I took the battery holder created by Yangorang, and remixed it to work with that universal pegboard system Parts To put it up on the pegboard, you will need to print the following pieces from the DDD system (I included the files here for convenience) 1 of 2x0 Flat Left sidepiece 1 of 2x0 Flat Right sidepiece 4 of 4x10x8mm Pin 1 of m12_battery_xX (choose 1,2 or 3) My print was no supports, 20% infill, but 3 perimeters for extra strength Instructions Insert the pins into the slots of the side pieces, then insert the side pieces with the pins into the battery holder. You will likely need a mallet/hammer to tap them in fully as they are a tight/strong fit. Make sure the orientation of the hooks is correct for the holder to face up! For more on how to use those pieces, you can see the wonderful DDD Printable Wall Control System . I will be adding a pull request for these pieces to their github repository, which is the primary place you should use for getting the files for the system as it is updated often