Misc border pieces for Honeycomb Storage Wall border

I printed a bunch of Honeycomb Storage Wall sections with my X1C and then printed what I thought would be all the border pieces to go with it. Long story short, I had to make a few smaller inserts where obviously the person who made the borders did not use the same HSW sections that I did. I'm guessing the border creator was using a smaller printer than the X1C. I included a picture of the four pieces I needed to complete my border. PLEASE NOTE, you are looking at the back of the models, which is the way you should print them. So keep that in mind when you are trying to match them to your HSW/borders. Also, if you need other sections just be very descriptive(with pictures) and I can make those as well.