Model of injection molding tool - mold with a case inside - money bank

I made this mould as a gift for a friend who is an injection mold maker (toolmaker). The model contains following parts: mold part 1 mold part 2 two rings ejector hook eye money box with lid The both rings, the ejector and the hook eye have to be glued. It was the only way for me to design it without using supports. Note: the diameter of the bolts is ca. 2mm less than the sleeves. I had my reasons for making it loose-fitting and not too tight. There is a space inside the mold, you can put a gift in and close the mold. There are also files for a round money box with lid. You can put money in it, and than put the box in the mold. You can also glue the bigger part into the mold and then use the flat lid for closing the box. I wish you a lot of fun with printing and assembling, mkrz Printing settings: You can print all parts with PLA, without supports, without brim. All parts need about 1oh of printing. The wooden pallet in picture is only for decoration, I downloaded it somewhere from printiverse and upscaled it to 200mm length.