modified solder tube holder

The original version wasn't working for me. It wasn't wide enough to hold my tubes of solder. I thought the tall version was too tall and the other one didn't provide enough support. I took the same idea but reworked it. For the top pegs, it's better if you can print that section 90% infill or higher - all the weight is supported on those pegs, so you don't want them to be completely hollow. The rest of it I printed 15% infill. I created a hole that runs from each cylinder to its neighbor and another that goes through to the back. This way, you can thread wire or a twist tie through to the pegboard for more support. You need some snips to break away the support plastic around the pegs.