Modular Desktop Fountain Remix - Two for One Pump!

Remixed the great Modular Desktop Fountain by 3D Printy so that both the plateau and pipe can be run off of a single pump. Changes to the original: Split Plateau Fountain: Splits a single pump source into two outlets, one for the standard plateau and a smaller outlet for the pipe Split Rhythmic Fountain Pipe Plate: I wanted to be able to fit 3 plateaus AND the full pipe so I moved the pipe to stand over two hexagon plates instead of just a single one. Fits great! Water Clip : This is just so the water doesn't wrap around the bottom of the pipe and splash out of the base. Also looks nice! I have the wider side facing the outside of the tube Pipe EndCap : This is to weight the backside of the pipe down. Also looks nice too! I have the hole facing down but you can also have it up for longer times between splashes. If the endcap doesn't stay in place, feel free to hot glue or super glue it in place Shorter Rhythmic Fountain Pipe : I shortened the pipe a bit so that it doesn't cause splashes out of the splash guard. The original is 140 mm long, this one is 120 mm. After using this, I haven't had a single splash outside of the fountain. Recommended : Remixed Splash Guard with no Leaks . This prevents water from leaking from the splash guard The rest of the fountain should be taken from the original model Modular Desktop Fountain by 3D Printy Extra parts: I printed another “Plateau Step.3mf” to go upside down on top of the Plateau Fountain to prevent splashes. Also printed a couple treefrogs to match the theme. Filament : SUNLU Black PLA SUNLU Copper Silk PLA IIID Max Blue PLA+