Neptune 3 Pro Frame Rail Bracket for Articulating Pi Camera Arm

Made this for the Elegoo Neptune 3 Pro to mount a webcam. But this should work on any 40mm dual slot rail printer frame. Supports needed touching buildplate. Articulating Raspberry Pi Camera Mount for Prusa MK3 and MK2 by Sneaks: https://www.printables.com/model/3407-articulating-raspberry-pi-camera-mount-for-prusa-m Used the 40mm dual rails off this model: https://www.thingiverse.com/thing:4228362 There are 2 models: EN3PRO_framerail_bracket_m is the orignal and EN3PRO_90_framerail_bracket_m is rotated 90 degrees. Neptune 3 Pro Installation: To install on the right side just pop off the back cap on the right side frame rails. To install on the left side of the printer you need to remove the entire front face plate.