Nerf Villainator shotgun drum!!

PLEASE READ EVERYTHING!! IMPORTANT NOTICE!!! This has not been tested yet so therefore I don't yet know if it will actually work. If someone tests it before I get a chance to, PLEASE let me know about any problems/feedback you have. This is the first part of my "Villainator conversion kit" which will include replacement covers with rails on them, potentially a stock replacement, a spring spacer, and this drum, of course. This shotgun mod will, of course, make the darts fall shorter than they would if it was shooting just one dart. However, that's what the spring spacer will be for. UPDATE!! Just finished V3, which is a model adapted for standard FDM printers. Like stated before, this design shouldn't need any sort of screw, so when you print it here you'll be ready to go. It does require a decently tuned 3d printer in order to fit though. Use supports of course. MAKE SURE YOU PRINT THE PIN SIDEWAYS, ON IT'S FLAT FACE!!! It will need supports, but it is supposed to be that way. Printing it sideways will greatly improve the strength of the piece, so the drum can last being put in and taken out. I haven't tested this tolerance yet. I would probably recommend super gluing it so you don't lose the pin in a battle, but it will most likely make it harder to spin. It should still be good though. If you print this, please let me know!!!