NexGen3D: Meshtastic ATAK Heltec T114 Case

New version of this here: https://www.printables.com/model/1017019-nexgen3d-meshtastic-atak-heltec-t114-case-v2 Note: I have ordered in some Beofeng clips, so when they arrive I will redesign the back cover to support them, so if your interested, check back as I will add an extra rear cover design for those that want this feature. This is a remix of this guys awesome design: https://www.printables.com/model/982046-h2t-case-for-heltec-t114-with-gps-running-meshtast I change the model for easier multi colour printing and changed some logos to suit my needs, also adjust to use a heat insert and few other minor alterations. I also have designed a magnetic dock that can not only charge the unit, but also allow firmware flashing, you can find it here → https://www.printables.com/model/1003414-nexgen3d-magnetic-dock-for-the-t114-atak-mobile-ca Model Requires: 1 x Heltec T114 Kit 1 x 803160 Lipo Battery 1 x M3 Threaded Insert 1 x 12mm SHS Just drag all the files in a given folder into your slicer and load as a single model with multiple parts and you can then choose the colour of each part seprately, all MM parts are only .6mm deep so only a couple of manual filament swaps are required. I like to use a different accent colour per unit so its easy to see which one is what when handing them out to fellow campers :) I printed this from PC-CF and the accent colours are done in ABS, much better materials for outdoors or for inside vehicles, other materials like PLA and PETG will end up warping if you live in hot climates like Australia.