Next Level Racing Flight Simulator Virpil Stick Adapter

Remixed from https://www.printables.com/model/1036434-next-level-racing-flight-simulator-winwing-orion-i This is made for the Virpil CS2 base, and should also fit other Virpil CS variants. It's sized for the 200mm virpil extension and works well for me with it. But other extension lengths could be used to further customize to your liking. I like it to sit fairly high. I printed in polymaker ht-pla which is reasonably stiff pla, at 40% infill and 4 wall loops. I could be happier with the stiffness, but I am also using the heavy springs fully torqued down with a heavy TM grip and it's livable, though it does bounce just a bit if you slap against the stops in any direction. I would expect better results for damper and chopper sim users with light or no springs. Or maybe using something even more rigid like CF filled would work better. There is just enough room to get a ball end allen key in for tightening. Step files are included for making your own mods and remixes. Note, I did not test print the loop variant for the support brace, but matched the position and size of the loops from the original design. *Added Version 3, Clampy Boi, Clampy boi eliminates backward flexing without the need for the front loops when you use stiff springs and bump against the rear stop of the stick. Requires 2 standard hose clamps which you can pick up at the hardware store for a few bucks. 2 1/2 inch seems to be the smallest size clamp that will work. Mount toward the back where the notch for the screw head is so you don't catch your feet on the band.