Ocarina of Time - 12 hole Alto C Ocarina

I will publish new Ocarinas only on MakerWorld. https://makerworld.com/en/@E.CAN3 📷 Image redacted — claim this model to add your own media This is my version of the Ocarina of Time in Alto C . If you like it, leave a like, if you really like it and you want to support me, donations are welcome ;) PayPal How does it sound? Thanks to Denis Kovalev for making this video. Changelog: Version 3 Reduced Airway hight, 1mm instead of 1,2mm, Teardroppier sounding Less airy Better breath curve Better sound Added a Version without the Triforce Version 2 Improved the soundhole for better breath curve, and better sound. Changed the design around the triforce a little bit. The Ocarina It is designed to be printed. The internal design helps to reduce airy high notes( Better sound, no Acute Bend). It is tuned: A4 up to F6 Standard 12-hole fingering All holes closed for A4, all holes open for F6 For A4 the required air pressure is low , more opened holes need more air pressure to hit the note. Print Settings Rafts: I use Brim Supports: No Resolution: 0.2 Infill: 20% Filament: Sunlu PLA+ Notes: Print orientation is on the moutpiece, no support, only brim if needed. 0.4 mm nozzle 0.8mm wall thickness 4 Top and Bottom layers Wall Ordering: Outside To Inside Walls before Infill. Bigger or smaller nozzles may change the tune. Any other Wall Ordering may change the size of the airway and the soundhole, resulting in a to small Airway and/or soundhole. Try to avoid stringing! It is hard to remove. The soundhole and the airway have to be printed clean. Blobs or other errors in this area can mess everything up. Glue the Triforce The Position of the Triforce when the mouthpiece is pointing upwards: U: upper segment R: right segment L: left 📷 Image redacted — claim this model to add your own media