Octahedroflake: Chunky Edition (vase-mode print)

I also did a “fuzzy skin” on the one in the photo. Same as my other model , but with bigger triangles. Same story. Don't resize . If you want custom sizes, send me a message. Slicing Instructions: There are hairline gaps in strategic places to make it a continuous perimeter. Normal slicing settings will close these gaps. You'll have to explain to the slicer that you don't want it to do that. (you'll have to enable at least “advanced” mode in PrusaSlicer to do it). Set the closing radius to zero. 📷 Image redacted — claim this model to add your own media Enable the spiral vase mode and give it just one bottom layer. 📷 Image redacted — claim this model to add your own media Optional: give it a short skirt so it goes right into the spiral after the first layer. 📷 Image redacted — claim this model to add your own media