Octopus ring holder

📷 Image redacted — claim this model to add your own media Dimensions (LxWxH) 82,9 x 105,5 x 39 mm (100% scale) Basic information The ring octopus has four tentacles dedicated to holding your rings, small jewelry, earrings, or basically anything else you desire. It's awesome for protecting your pieces from getting lost while you're not wearing them, or it can be used for a creative and playful display of your jewelry. Files information You can choose from total of 2 files: .stl ; and .gcode (for MK3S+, pre-sliced, ready to print) 📷 Image redacted — claim this model to add your own media Material PLA Layer height ≤0,2 mm Infill ≥5% Support Yes, touching buildplate. Necessary for the tentacles. Proceed carefuly when removing. Scaling Possible, downscaling not recommended. The tentacles are quite thin, and they might not come out too great on the downscaled version. Orientation Default Adhesion aid Not necessary, contact area with the buildplate should be sufficient. If your print surface suffers from poor adhesion, consider using some adhesive spray, or other kind of adhesion booster. Using brim is a possible alternative. 📷 Image redacted — claim this model to add your own media In this section, you can find a list of all updates and fixes, which were introduced to the model along the way. Each update will be explained thoroughly, so that you know, which issue was every specific update adressing. If you're having any problems with the model, you can check here, if a new, revised version of the model, has already been released in a response to your problem, or not. If you run into any issues with the model, please pay a visit to the section of known issues, which can be found just below the Updates and fixes. If you won't find your specific problem there, don't hesitate to contact me via dm. The model hasn't been updated yet. 📷 Image redacted — claim this model to add your own media There currently aren't any known issues/work in progress. If you run into any, please contact me via dm. 📷 Image redacted — claim this model to add your own media My work is free for personal, non commercial use. If you want to sell, or monetize my models in any other way, please visit my Patreon for more licensing options.