PanelDue 7i case and mount with swivel head LOW HARDWARE.

(information not written by Ai) WHY I DID THIS: I know it's a old LCD for a older board but I had a brand new one laying around and I have a duex5 so I'm using it to upgrade a old DIY CNC laser that was running on a skr1.3 with TMC 2209's to be a laser platform prototype that uses multiple lasers and more than one coordination pathways to complete a unique manufacturing process. And the original pattern was not my style and I needed more of a scifi looking work of art with way less necessary hardware. Features: Top bezel snaps in to Mounting frame with a protruding male ball joint. no need for hardware. retains motherboard with pins that can be easily snipped off if you decide to bolt it in. Also is equipped with 2x M3 threaded holes so you can take any typical recycled computer screws and they should fit. but you may not even need them. I guess you could also glue the tabs on if you never want to open it again. The bottom Base mount with the hollow female ball joint has 5mm holes to mount it to extrusions or any surface you poke holes in. EXTRA features : Extender LINK: You can now extend the neck as far as desired by adding more links. Manufacturing instructions:>>>>>>>>>>>>>>>> Print at 100% solid infill. Position the part in your slicer at an angle never flat on the bottom You can print the front Bezel on a patterned hotbed plate/sheet flat for textures. But the rest is too thick and will elephant foot if you do, so tilt everything. I used automatic tree supports with a raft. I printed in ABS Remixed changes: Turned power button into a skull. Put hexagons over speaker. And built the entire back mount by scratch. Pretty much didn't use anything but the basic outline of the bezel for this remix.