Parametric Silicone Nozzle Cleaning Brush Mount for K1C

After adjusting the bed level using springs and knobs ( link ), the overall height of the build plate increased by approximately 5 mm. Because of this, the original mount I was using ( link ) no longer fit properly. Additionally, when printing on 4 mm thick glass, the original bracket would bend significantly due to the height and lack of support. To solve this, I designed a parametric silicone brush mount that you can customize to match your setup using two Fusion 360 parameters: bedHeight – to adapt to the new bed height brushesWidth – to match the width of your silicone brush You can easily adjust these in Fusion 360 using the "Change Parameters" dialog. 📷 Image redacted — claim this model to add your own media Printing Recommendations: Supports required Recommended materials: ABS or PETG PLA not recommended due to low heat resistance