Pegboard Shelf

It's a shelf. Stable, 90 degrees, pressured between support and pegboard to stay firm. Designed for 1/4" holes spaced 1" apart. Shelf is 10" wide by 7" deep. Feel free to ask for other dimensions. No supports needed. PLA 10% is plenty strong, feel free to go higher. Printing Tip: There's a small lip on 3 of the sides to keep things from sliding off, so make sure the front lip is down on the plate so you don't have a small overhang on top. Installation: Hooks the supports into the pegboard, I usually only use two although there is a slot for a middle one if more support is needed. Then insert the shelf on top and push it down into the slots.