PETG Strap for the Prusa Protective Shield

Simple remix which extends out the holes from the TPU model which connect to the faceshield. I found the provided holes were not flexible enough to use with PETG. Print instructions Printing in PETG at around 70 for the bed and 225 for the extruder. Using "Dynamic Quality" - 0.16 layer height in Cura worked just fine. You can slow it down if you want higher quality. Printed in about 50 minutes. Model contains both pieces of the strap for printing to make my life (and hopefully yours) easier. This is just the straps, see the original for links to the actual face shield.