Phone Stand for Phones with Cases (allows for charging cable)

I'm sure you are all familiar with this design by now, it's a remix of an existing model with an enlarged holder to accommodate for thicker phones, even with cases. Includes a cutout to allow a phone to be held whilst charging, making it more convenient than other stands. Model can be printed in one piece with supports, or to print without supports, print both the positive and negative halves and glue them together using the pins to align the two halves. Print Settings: Layer Height: Any layer height will work, but looks best at smaller layer heights Supports: Yes for single Piece. No for two-half version. Material: Any - depending on settings, printing will consume ~50g of material. Perimeters: Would recommend at least 2 perimeters/walls. Infill: Any pattern with at least 5% infill density to give some rigidity.