Pi camera servo arm for octoprint

Notice: it's not only for the ender 3 v2 Model descriptions: arm rail mount for a aluminum extrusion (tested on ender 3 v2 extrusion) this one the just tall enough to peak over the ender 3 v2 bed height, this is around 10 cm and 12 cm including the camera hight. the rail is from @ryanba “ MODEL LINK ” smaller rail mount (tested on ender 3 v2 extrusion) the rail is from @ryanba “ MODEL LINK ” arm mount for on QR code, so it moves with the Z arm. (double sided tape is recommended) remixed from @3ddruckmarc “ MODEL LINK ” mount made for the QR Ball joint Arm (I recommend not using joint in-between) the mount point for model 5, this model is designed by @Anders “ MODEL LINK ”, which is a remix from @3ddruckmarc “ MODEL LINK ” Credit for all the models used in the renders: picture 1, 2, 5, 6, 7 and 8: ender 3 v2 model used is from: @pakkko_354438 “ MODEL LINK ” Servo reference model used is from: @demetrius_393003 “ MODEL LINK ” Servo Arm/Horn used is from: @Cohenco “ MODEL LINK ” Ball joint QR mount used is from @Anders “ MODEL LINK ” that is a remix the qr cover of @3ddruckmarc “ MODEL LINK " the models for the arm joints used are all from @Erer “ MODEL LINK ” I use: a Modular Snap Together Raspberry Pi @Sneaks with a Ender 3 V2 Mounts rail @ryanba , with the model 1 Arm rail mount for a aluminum extrusion . and I use a raspberry pi with octoprint. And for the servos I use the Micro servo 3.9g . with the Easy servos plugin on octoprint. And on the pi i connecter the gpio 22 for the x and 27 for the y IMPORTANT for octoprint You can use a octoprint plugin to control the servos. the plugin called easy servos made by mledan , iFrostizz and jneilliii . In the image below, you can see the controls and my settings. how to set-up is described on the Plugin Repo “ LINK ” 📷 Image redacted — claim this model to add your own media 📷 Image redacted — claim this model to add your own media ^^ these are my settings for easy servo Thanks to @Erer for the original model.