Pickleball Racket Adapter For Meta Quest 3

Updated on 27 February 2026: A hole has been added to prevent blocking the rear LED on the controller. The gap between the handle and the blade has been reduced from 0.3 mm to 0.15 mm in order to improve glue adhesion. #Instruction: Since this is the remix of BonWasySX, it's printed the same way and uses the same mechanics to mount the controller. So please check the original mode for instructions of the "blade" part. https://www.printables.com/model/686026-v20-quest-3-table-tennis-adapter As for the "handle" part, don't get too crazy about the print speed. Use brim as needed. 10~15% honeycomb infill should be fine. After printing, glue them together. You will also need grip tape like this: https://www.amazon.com/pickleball-grip-tape/s?k=pickleball+grip+tape PS. It also seems to work on Quest 2, just with a little wobble without the screw. If you want to try it on Quest 2, do so at your own risk. Updated@2024/6/13: I made a stupid mistake by uploading the old version of the blade which was too long, I replaced the file which is 30mm shorter. Sorry if you've already printed it. If you can cut the blade 30mm from the bottom, it should fit. If you like my work, you can buy me a coffee :) coff.ee/kaiha #Others: I also sell my own version of the Pickleball Adapter on Etsy and BOOTH. If you're interested, please take a look. Japan shop: https://5kaiha.booth.pm/ Gobal shop: https://www.etsy.com/shop/KHStudioJapan