Pikachu Lamp remix

Print using supports in almost every part. For lightings, best print in cura, using tree supports, 3 perimeters, 3 top and bottom layers, this way al interior is completely clear, in prusaslicer I cannot print it clean lot of artifacts remixed for usage arduino nano and led strips 2812b. Build is rather similar, just need to solder lights, mantain signal from first to last led. only 18 leds and upload code to arduino. order is as follow leds_head_pikachu.stl holds 4 leds, and are first on montage led 0, red led 1, yellow led 2, yellow led 3, red led_base_pikachu.stl holds 2 leds, led 4, yellow led 5, yellow tail.stl holds 3 leds, led 6, yellow led 7, yellow led 8, yellow remember to use same signal wire or will not work, mantain order. once pikachu asembled, let enough cable to work confortably, all cable will be hidden in base so no need to be extreme clean all remaining leds are in light blue, so no need to be carefull in this part, just remember to mantain signal wire in correct order 3 lightings, needs 6 leds, 2 for each one led 9, blue led 10, blue led 11, blue led 12, blue led 13, blue led 14, blue finally, just need to mount impact, this one holds 3 leds led 15, blue led 16, blue led 17, blue just glue remaining parts and job finished. also you get the arduino code, easy and no complications, plug, compile and start lighting. Arduino uses a button, with this one, you can control light, it has 4 brightness and an off position. in the pin data cable, add a 10k resistance, to avoid bugs. thanks to rayjizza for allow me remix this fantastic model. https://youtube.com/shorts/KdQprj2fj3s