Pioneer DDJ FLX 4 Controller Angled Stand Feet

These 3D printed feet raise your Pioneer DDJ-FLX4 by approximately 4–5 cm and tilt it back ~10° for a better view of the jog wheels and more comfortable operation while standing or sitting. Advantages: Stable and non-slip (pre-designed spots for 11.6 mm rubber pads) ~10° tilt angle for improved usability Quick install: no glue or screws required Precise fit for the original Pioneer DDJ-FLX4 Optional caps to cover overhang print lines Included in the 3MF file: Both feet (left + right) already placed side by side Optimized print orientation Recommended print settings: Material: PLA or PETG Layer height: 0.2 mm Infill: 15% Gyroid Walls: 2 No supports needed Print time: approx. 2.5–3 hours per foot Material usage: approx. 120 g per foot Optional: The small caps (separate 3MF file) can be glued into the recess to hide typical overhang lines. Tested with the original Pioneer DDJ-FLX4 controller. Note: This is a light elevation only – not a replacement for large risers. Feedback, makes and remixes are very welcome! Licensed under CC BY-NC-SA (attribution + non-commercial + share-alike). Happy printing!