PIP Mobile Stand Case

Simple box with a little flair! It will hold 14 of occupied_brain's print-in-place phone stands. If your tolerances are dialled in this should print easily, however some XY scaling may be required. Bill of Materials: 4x2mm magnets ( 4 OFF ) Box ( 1 OFF ) Lid ( 1 OFF ) Detail ( 2 OFF ) Piece of 1.75mm filament (1 OFF) Super glue Printing Recommendations: Box and lid PLA, PETG, any low-warp material Arrange with flat sides on build plate 0.4mm nozzle 0.10 - 0.20mm layer height 15% gyroid infill or 25% adaptive Infill combination ON Supports OFF Detail PLA, PETG, any low-warp material Arrange convex on build plate 0.2 or 0.4mm nozzle 0.05-0.12mm layer height 100% infill Infill combination OFF Supports OPTIONAL Small footprint => ensure strong bed adhesion