Plant Stand - Simple Mid-Century Modern Planter Holder - Easy Print - Multiple Sizes

v2 Update Notes: I have slightly re-designed this model for improved structural stability. Featured in this update are slightly thicker legs, a thicker platform, and a reinforced section between the legs to minimize flex and increase the weight capacity. Sizing is the same across all models. Although the visual changes are minimal, if you prefer the look of v1, the old files are still available in the “v1 Files” folder. Plant Stand - Simple Mid-Century Modern Planter Holder - Easy Print Preface: This is a simple, easy-to-print plant stand that channels mid-century modern themes. When printed with the right settings, these plant stands are very sturdy and should hold even very heavy plants. Featuring a chamfered platform edge and three legs that seamlessly blend into each other, this plant stand will fit in with any decor style. There are a total of nine model files, each with a different height/platform size combination. The first number refers to the platform width, and the second number refers to the overall stand height. For example: "Plant Stand 001 7.5W 6H" is 7.5in wide and 6in tall. Printing: These models print upside down, so I recommend using a textured buildplate if possible. This is not necessary, but will make the result look better in my opinion. I recommend the following settings: 4 walls 30% infill 0.2mm layer height Note: I have found these settings to produce very sturdy results, but if you have an especially heavy plant that you're planning on using this for, I'd recommend increasing to 5-6 walls and 40% infill just for good measure. Other notes: The picture prints were completed using Elegoo Matte PLA. This model is not for commercial use. If you are interested in selling your 3D prints of my models, please refer to my Printables Club! If you like this design, consider leaving a tip! I'm a university student, so anything helps! https://www.paypal.me/theprintedplanter