Pole mount for articulating arm

This is an alternative mount for the Flexible & sturdy phone arm (100% Printed) by FunkyArt . It is intended to slip into the top of a pole that is used for monitor mounting. The inner diameter of your pole should be around 32-33mm for this mount to work. If you happen to need a different size, let me know, I'll throw one together and send it your way. If you find it a bit too loose, you can wrap a bit of electrical tape or similar around it before slipping it in. I recommend slipping a bit of grease onto the mount before slipping it into the pole, that way it will rotate within the pole allowing you to reorient your arm. Enjoy! Print recommendations: Due to the steep cylinder cutout, I recommend printing this model slower than you might expect. For the same reason, I recommend z-hop. Due to the forces this piece will experience, print it out of the strongest material you have, with maybe 4-5 walls. Don't be like me and use silk PLA unless the part the arm is holding is very light.