Pop-up credit card wallet spreader with money clip

I printed the back with clip mount with 4 walls and 15% gyroid infill. The money clip is printed on its side in PETG and 6 walls (shouldn't be any infill) and .2 layer height, with a brim and no supports. The clip with the cutouts on the sides was printed with supports and the previous settings. Requires 2 - M3 6mm screws with nuts for the money clip and 4 - M3 12mm screws and nuts for the body. The spacer is printed in PETG, 3 walls, .2 layers, 15% gyroid infill.