Print-in-place dual fidget ring

Double the fun with this new dual fidget ring! If you like the standard fidget ring and grew too accustomed to it, this one will give you some good alternative to play with. Be aware that you need to switch on support in your slicer, as seen below. You get many sizes (inner diameter in mm from 14mm for kids to 22.6mm for big fingers. Please use the conversion table below in case you are used to your local ring size. There will be different ring widths as well ("normal" - as seen in the picture, "thin" and "wide"). The STL filenames have both the style (normal/thin/wide) and the inner diameter in mm in the filename. In case you need even more different sizes, please install OpenSCAD on your own computer and follow these instructions to customize your ring. Unfortunately, the uber fidget ring was deleted due to a design claim, so its no longer available. Thanks go out to aubenc for the knurledFinishLib_v2 . If you could take a picture of an actual print, please “add a make” and attach the picture. - I am curious to see your uses in the wild! Please let me also know how you rate the design. If you like it, please have a look at all my customizable creations . There are more configurable-text-based creations, multi-line label , gadget display stand , sweeping name plate , bunting banner , customizable text box III , pyramid text , name plate , Customizable text box with lid and round text . Have also a look at my configurable pack of dogs , rabbits , reindeers and santas . There are also useful coat hangers and finger toys . Or just check out all my creations . Print instructions You will need support: In PrusaSlicer, switch on support material , set overhang threshhold to 0 for automatic detection, set style to seamless . This is the most important, as it will reduce support material considerably and just creates a thin support ring around the main ring. The support is then easy to remove, just peel it off. You can see the support in green in the picture below. 📷 Image redacted — claim this model to add your own media The ring still prints very fast, in 30mins. Other standard settings will be fine, like infill of 20%, layer height of .2mm, 2 perimeters. After printing, remove the support material and turn the rings a few times to make them spin better. If you like it, check out the original print-in-place fidget ring : 📷 Image redacted — claim this model to add your own media The mark I discrete fidget ring : 📷 Image redacted — claim this model to add your own media And the discrete fidget ring - Mark II : 📷 Image redacted — claim this model to add your own media The Longitudinal fidget ring : 📷 Image redacted — claim this model to add your own media Ring size conversion table: Ring inner diameter in mmUSA CanadaUnited KingdomFranceGermany14.0 mm3F441414.4 mm3½G45¼14½14.8 mm4H½46½1515.2 mm4½I½47¾15¼15.6 mm5J½4915¾16.0 mm5½L50¾1616.5 mm6M51½16½16.9 mm6½N52¾1717.3 mm7O5417¼17.7 mm7½P55¼17¾18.2 mm8Q56¾1818.6 mm8½Q½5818½19.0 mm9R½59¼1919.4 mm9½S½60¾19½19.8 mm10T½61¾2020.2 mm10½U½62¾20¼20.6 mm11V½64¼20¾21.0 mm11½W½662121.4 mm12Y67¼21¼21.8 mm12½Z6821¾22.2 mm13-692222.6 mm13½-- -