Prusa Mini handle

Sure, there are a few handles on here, but they are all smooth and round. This one better fits with the angular nature of the printer and the mods I have. Also, no supports. This prints flat on its side. Will your hoooooge hands fit? I would expect so. The gap is 30mm from the frame by 100mm at the narrowest bit in the middle and the handle itself is 25mm in 'diameter'. Print instructions Nothing magical required, 0.2mm layer height, 0.4mm nozzle, no supports... Mounting is with the standard M5 T-Slot hardware. 8mm bolts are fine, 10mm are also good.