QUICK-CLIP (GEN 3) Perpendicular buckle remix

The combination of printer/slicer/filament choice I am using was causing the tops of the original buckles to come out slightly deformed due to the 90 degree overhang. Some slicers have settings to compensate for overhangs like this but I figured this was easier to make than changing slicers or tuning my printer. Initially printed out of ASA using a 0.4mm nozzle, 0.4mm line width, 0.2mm layer height. I would recommend at least 3 walls and top/bottom layers. The original design is very good in terms of printability so whatever works on your printer is probably fine.