rain.Fram3 - A Rainmaker Insert for the Fram3 CMF Phone 2 Pro Cover

About This model is a set of inserts for the Fram3 cover that is compatible with the CMF Phone 2 Pro. 📷 Image redacted — claim this model to add your own media The design is inspired by a combination of liquid motion timers and rainmakers. 📷 Image redacted — claim this model to add your own media This insert was supposed to be a liquid motion timer but the insert dimension did not allow for a proper “dropper”. Additional Supplies 1mm Acrylic (dimensions below) 0.25mm diameter (or smaller) Beads or Ball bearings 1mm Acrylic Dimensions The following dimensions have 0mm clearance. Top: 31mm x 31mm Middle: 66.5mm x 88.75mm Bottom: 37mm x 12mm Required dimensions may vary due to individual printer tolerances. Printable cutting templates have been included, but are also subject to variation printer tolerances. 📷 Image redacted — claim this model to add your own media Slicing & Printing Orient model with the open side facing up. Disable supports. Add a pause after the retaining wall is printed / before the sealing layer is printed. Print until the pause. Add beads. Place acrylic sheet. Continue print. 📷 Image redacted — claim this model to add your own media All First Party Insert Sets a.k.a “Inserts I Would Use” sand.Fram3 (Sand Timer) charm.Frame3 (Shaker Charm) HERE! rain.Frame3 (Rainmaker) 📷 Image redacted — claim this model to add your own media