Raspberry Pi Pico Case

A simple 2 parts snap-fit case for Raspberry Pi Pico. No screws needed. Back of case is open for wires. I use it to connect 2 ADXL345 and do the input shaper in Klipper Print settings: layer: 0.16 or lower perimeters: 3 To connect 2 ADXLs use the following pins. For the second ADXL you will need to use GPIO8, GPIO9, GPIO10 and GPIO11 according to the colors. Red and Black are the same. 📷 Image redacted — claim this model to add your own media Klipper Configuration [mcu pico_adxl345] serial: /dev/serial/by-id/usb-Klipper_rp2040_use_your_id-xxxxx [adxl345 head] cs_pin: pico_adxl345:gpio1 spi_bus: spi0a axes_map: -z, x, -y #update your axes mapping [adxl345 bed] cs_pin: pico_adxl345:gpio9 spi_bus: spi1a [resonance_tester] probe_points: 115, 115, 30 #update your position accel_chip_x: adxl345 head accel_chip_y: adxl345 bed If you need a bed mount for ADXL take a look at this . Updates 21.11.2022 - Add pins and Klipper configuration 22.07.2022 - Version 2.1 - add a cutout for the Bootsel button. 12.07.2022 - Version 2 - add an indentation in order to make the case more snap-fit and prevent to become too lose from wearing.