ratgdo 2.5i Enclosure with Wago 221 Lever-Nuts & M3 Self Tapping Support

This is a remix of the original ratgdo PCB Case from @samwiseg0 along with the awesome remix from @PatrickONeal_471773 that added support for Wago connectors to improve wiring support – Wago connectors will change your life! The original Wago integrated version noted that it was only for the case that used screw inserts (melting) and did not contain a version to support self-tapping M3 screws which is provided by the original PCB case version. Notes: Printed, Composited, & Exported with Cura v5.4.0 The Wago holders are a very tight fit and takes some force to insert, but once they are installed all clips open without any issues. Print Settings (Same as Original PCB Version): 4 Perimeters/walls 5 top and bottom layers 25% Gyrioid Infill 0.4mm line width Parts are pre oriented in the correct position for printing No supports!