remix Phone holder Arms with Rotary holders

There are two length arms. Original about 95mm and longer at 105mm. I needed the longer so the arms cleared my buttons. I also needed a solid mount to get rid of the phone ejecting from the holder when hitting a bump. This exit problem is because my mount is is close to vertical. Since making this change the problem of the phone leaving the mount has ended. This is a great mount. I have used it for over a year. These adjustments are for my new phone which is taller and heavier. The end is rotary cut to fit. I am providing many options. square cut in the rotary based on thickness of the phone 6mm to 10mm lens cut version for each thickness. This has a recessed cut to allow lens bezels to not hit the arm. I have a Supcase, so that cut is available as well. The grips rotate 360 degrees. You can glue them in place once you get it fit to your phone. Because of the cut a small support will be required . I did not try these arms, they look promising at providing a good hold. I did not try these. Also not the arms in this link are from a different remix and will not work off this remix. https://www.printables.com/model/1206314-phone-holder-the-remix-of-the-ingenious-design-by