RepRack Retension Clip REMIX

Looking back, I probably should’ve figured out how useful those Retention Clips are before installing my RepRack. Would’ve saved me a good amount of sweat (and a few questionable words) while wrestling the rods and their locking screws into place. So here’s my tip: if you’re building a RepRack and printing the parts anyway, don’t skip the clips. They only cost about 1.5 grams of filament each, and they’ll make your life a whole lot easier—and safer, too. Printing information All STL files are correctly aligned. Layer height: 0.2 mm Perimeter: 2 Infill: 15 % Support: no I am looking forward to your Makes! :-) If you like this design, feel free to check out my others here .