RollBack Truck

This model requires most of the original Prof-Boots files, with the exception of the Rear Frame. It also incorporates Reid12's winch from his MiniSkidi remake. Additional Electronics Required: 1x N20 100mm M4 Threaded 12V 1000RPM motor for the slide deck https://www.amazon.com/dp/B0DBG3NP3Y 1x N20 55mm M4 Threaded 12V 1000RPM motor for the Pivot https://www.amazon.com/dp/B0CMK5WWFM 1x N20 12V 300RPM motor for the Winch This design uses the ProfBoots PCB with the Winch going to AUX2, the Deck Slide AUX1, and the Deck Pivot AUX3. The controller has been slightly remapped so Forward/Back/Left/Right is all on the Left Joystick. The winch is Up/Down on the Right Joystick, Deck Pivot is L2/R2, Deck Slide is L1/R1. all other controls are untouched. Some of the parts are designed to be glued into place, like the Cable Tray, the Slide Motor, and the upper pivot bar. Cable routing for the Winch is achieved by wrapping a coil of wire around a small screwdriver, and trapping the coil between the deck and the Tilt Bed. 8/13/25 Update: I added a mounting bar for the Sliding deck to mount a light bar on for this light bar: https://www.amazon.com/dp/B0761RPS4V I modded the Tilt Bed to add a cable tray on the left side. the Winch motor is now routed on the left cable tray, and the lights are routed on the right cable tray. Plug the light into LT3. I modified the code to activate LT3 when the Hazards are on. Cycle the Hazards once to turn the light bar on, cycle the hazards a second time to turn it off. The Rear Frame is also modified to increase the size of the cable routing. See it in action here: