Rotating turret for Halo Warthog

This replaces just the turret from the original Halo Warthog by Kmech Toys. It is two separate pieces that are in their printing orientations. Once printed, glue the gun to the top of the turret (which should have the outline for the placement on the top). Once set, put glue on just the bottom outer ring of the base and then press down onto the bed of the Warthog. I used my finger on one side and a pick on the other to hold it in place initially, but any small screwdriver would also do. As it starts to set, be sure to rotate the center & gun while pressing down on the outer ring so that it stays free moving.