Rubber Band Plane

Instructions: Print flat on build plate at 0.2mm. No supports/brims needed Let build plate cool sufficiently before removing from bed. To assemble: Flip it so that the protrusions face down Bend the vertical stabilizers up 📷 Image redacted — claim this model to add your own media 3. Adjust the elevators as needed 📷 Image redacted — claim this model to add your own media 4. Heat up the thicker part of the propellers bend 45 degrees 📷 Image redacted — claim this model to add your own media 5. Insert the hook of propellers into hole on body 📷 Image redacted — claim this model to add your own media 6. Hook on the rubber band Optional: Bend the wings up for better flight Apply WD40 or any lubricants onto the contact points of the hole and hook for less friction To use: Turn the propellers sufficiently Hold on the the propellers and place the plane on the edge of a table Make sure the 2 hooks are on the edge Let go of the plane and propellers to let it fly! 📷 Image redacted — claim this model to add your own media Took inspiration from: https://www.printables.com/model/430012-ultralight-2gram-glider-print-in-place and https://www.printables.com/model/35485-flying-surprise-butterfly-toy-powered-by-rubber-ba