Sharpener Micro Adjuster

This adapted design of the original project came about as a result of the lack of appropriately sized hardware, and need for a 3D printable alternative. So I combined the Fine Tuning Adapter for Knife Sharpening Jigs, with a resized and modified nut and bolt from the NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory collection from here on Printables. Also because the main source model is from Thingiverse I cannot list it in the model remix section. However, I am stating here that all of the credit for the creation of the original, high quality, model that I used for this remix goes to Burt at Leadingedge on Thingiverse. Here I have included a link to the original print. https://www.thingiverse.com/thing:3644585 Print Settings: Printer: Prusa MK2S+ Filament: CPE, or Tough PLA Layer Hight: 0.15 Infill: 80% to 100% Exterior Perimeters: 5 Brim: 5mm Heated Bed: Recommended Supports: Everywhere, snug, and at 43 degrees overhang threshold. Approximated Filament Usage: 3.79m Approximated Print Time: 1 hour and 38 minutes.