Shelly 1PM Din Mount Wago 221 w Temperature Sensor Hub

I'm making a new demarcation box for my garden & pond controls w shelly parts I planned to add to older crammed panel - much of my controls are IOT, decided to connect shelly & sonoff) to din rails. for the AC/DC, sensors, pump & valve controls. Needed a mash up/extension/mods of the 2 source models of @boinappi_456319 & @MarcNeuhaus shelly din mounts to fit IoT 1/1PM Temperature Sensor Addon, to replace/modify slide din clasp used in the shelly plus format version ( a la @MarcNeuhaus ) on to the shelly 1/1PM version body (a la @boinappi_456319 ), adding additional wago holders for the sensor probes connections. Thickened the holder to account for the heat & temperature sensor add on (now flush with holder face) https://shellystore.co.uk/product/shelly-temp-addon/ (which i just learned has been discontinued). The additional width accommodate 2, 3 & 5 lead 221 's. Added push points in case you need to remove/replace the wagos. Added larger nodes to the tension holders as I found the holder a tad to roomy to old the 1/1PM in place securely. Marc's wiring for the Shelly the the holder https://www.printables.com/de/model/284123-shelly-din-mount-with-wago-221-terminals I printed this on a taz4 60c bed, 205c hot end using 2.85 matt black polymaker PLA sliced with Taz version of cura set for fine, 2 wall, 3 face, 15% infill with short side slice termination. Printer was set for 90% feed rate. If you want/need, enjoy!