Simple any magnet size Bambu Lab P1P/P1S/X1C Poop Chute [Remix]

Materials needed: Super glue, any size magnet. This model is 3mm thick on the bottom, 2mm around the curved area, and 3mm thick on the wall where the magnets go. I have 20mm x 5mm x 2mm magnets so I made mine with cut outs for that size which is in the file below. I also included a blank copy so you can import it into tinkercad and cut out the size/shape of your own magnets. Using six 20x5x2mm magnets may have been overkill but I don't mind cause it's stuck nice and secure to the printer. I suggest using magnets that are 2mm thick so it has an extra mm of support behind it if you have some on hand. If you have magnets thicker than 2mm it would be really simple just to add more wall to the inside of the model via tinkercad, then cut out the size/shape of your magnet. I printed this at .2mm layer height, and it took about 4 hours to finish. No need for supports at all, and I used rectilinear infill, and it came out perfect. Once it's printed just super glue in your magnets and you're off to the races! If you make a print of your own I'd love to see the make, so give it a post! Thanks for looking!