Six Pack - Coca-Cola - Print in place

This must be the most radical remix of the battery box - a coca cola six pack for drinking cans. The remix credit must go to the original from CAD-Guy, but the crate I have used is this version from Chong-McBong https://www.thingiverse.com/thing:5356930/makes, while it is the best stackable version I have seen. Almost everything has been altered, wall thickness, new bottom design and a carrying handle. I have included a picture for comparison with the small battery box and my six pack version. STL-files in two versions, one for single color printing and one for MMU printing. In single color printing you have to make a color change after layer 3 (3 x 0.20mm) when printing the small and large logo plate. I just glued the plates with superglue. Printed in PLA (Chilli Red and Warm white) Layer 0.20mm (Quality) Ironing: Logo plates: Topmost surface, Flowrate: 35% Support needed at all bridges (6 around the edges and the center handle) I used snug support. It is strongly recommended to add some adhesion where the carrying handle are touching the heat bed because it is 131 mm high. No doubt that the cleanest and best looking coca cola logo is produced with single color printing. Happy printing and drinking!!!!