Skadis Round Screwdriver Holder

This was made with the ratcheting screwdriver I use in mind. (Milwaukee 48-22-2903) But it should accommodate any screwdriver with a diameter of 30mm or less where the shaft goes into the handle. Print Settings I used: LAY ON ANGLED BOTTOM LAYER FOR BEST RESULTS (Shown in Picture) Printed in PETG .20 layer height 3 walls 20% Cubic infill Organic Tree Supports for the pegs Remixed in TinkerCAD https://www.tinkercad.com/things/2PvVFRQR9qA-skadis-round-screwdriver-holder?sharecode=9nIoeHOvkf_YRO8B2JvBPxTAFQJFcTum5Vq1SlZ33fE