Small Screw Box V02

When printing: *** I found that printing with a .6 noz was fine for all models but the Cabinet. I suggest printing the Cabinet last and test print the back of the Cabinet(stop the print at maybe 30%) and then test to see if the tray with a Box will fit. If its to tight, increase the Y direction of the model in your slicer.*** I really liked this Box with Lid design. So much so that as I was printing I wanted to Add more options for a Customizable Build. With these models you should be able to Print a Cabinet set type of tool box for your small parts. I found that the tolerances were a little tight for me when test printing the small box. Printed with a Ender5Plus with a .6 nozzle to bring the print time down (i know i should have printed with a .4, didnt want to change and the nozzle :-) ). Changes i made/added: -Box Decreased the inner lid lip. Increased the gap for the latch to get by the front notches Added a 2-4 slot box with a Fillet to help with getting small parts out -Tray Changed the Handle. Added a Small version for 3 Boxes. -Cabinet Added the Foot to the Top so that you can Screw together Top and Bottom when combining Cabinets. Added a Small Cabinet for the 3 Box Tray version. Added 3-8 Tray Slots incase you need a fewer Tray setup. Added Handle and non Handle versions for all Tray versions. Handle is a bit forward on the model so that when you pick up the Cabinet it will tilt back so that the Trays will not fall out. The idea i had for this is to have a Handle version in the middle of a non Handle version on the left and right. Doing this you can build a Small Tool Box for small parts. ***Edit Fixed the gap in the below models. cabinet-small_w-Handle_3Slot cabinet-small_w-Handle_4Slot cabinet-small_w-Handle_5Slot cabinet-small_w-Handle_6Slot cabinet_w-Handle_6Slot