Snap-on frame mount for K1C / K1SE for articulating camera mount

I was inspired by Articulating Camera Mount models by @Sneaks and @Mathieu_340410, but needed a way to mount the setup on my K1SE frame. This is a quick snap-on model I managed to create in half an hour in freecad. Print with automatic snug supports, everything else is as you wish. I used 0.24mm layer height, 15% cross hatch infill, 3 bottom 3 top 3 walls. Printed out of PETG, did not try PLA but the flex on the snapping is not so great, so I think it will be ok. If it fails - try laying it on the side and printing with the supports under the circular part. It will surely lower the quality of the connection, but might be just enough for your print not to snap in half.