Sovol SV06 Camera Bed Mount, Raspberry Pi Zero

Corner mount for the Sovol SV06 hotbed, for use with Pi Zero with Pimoroni Camera Module, though can easily be adapted for other cameras. Printed in ASA, to withstand the heat of the bed. May be acceptable in PETG, if only printing at low temperatures. The mount can be printed without supports but the case will require some. I have also included small braces for the case, for peace of mind, given that it will be subject to a lot of movement. To mount, simply remove the screw from the top of the bed and slide out the spacer. Insert the spacer into the hole in the printed piece and then reassemble. The Pi case is attached with an M3 nut and an M3 x 16mm bolt. I have only included the amended back here, the other parts of the case can be printed from the original model: Ultra small Pi Zero Case with Pimoroni's Pi Camera Module